Uvp TB-101 Selector Switch Manuale Utente

TB-101 Rev STD TTeecchhnniiccaall BBuulllleettiinn TTBB--110011 Transilluminator Selector Switch Replacement Overview The purpose of this Tech

12. With the two sets of two small holes on the filter frame facing toward the front of the unit, replace the transilluminator filter frame on top of

4. Remove the four Phillips-head screws and washers securing the transilluminator filter frame to the body of the transilluminator. Lifting up, remo

6. Inside the unit, locate the side reflector panels which are two reflective metal panels located at each end of the transilluminator light tubes. N

9. Note: Prior to completing this step, make a note of the location of the transilluminator selector switch wiring on the gray wiring junction block.

Installation Procedure 1. Looking at the front of the replacement selector switch, note the position of the alignment tab. When installing the new s

4. Thread the securing nut onto the shank of the selector switch. Hand tighten the nut, and then use the pliers to tighten the nut snugly. Again, ver

6. The selector switch knob does not have a groove or flat surface to align on the selector switch shank, so it is necessary to visually align the wh

8. Route the wiring from the selector switch to the gray wiring junction block. Using a flat-head screwdriver, press in on the gray square while push

10. The side reflector panels must be aligned with the main reflector panel during reinstallation. a. A small metal tab (a) protrudes from the sid